Post A Picture Of Your Current Job (Part III)
1 reading
Admin
861 - 880 of 11,955 Posts
Screwing boxxes on the wall:blink:
Way up on top of a hill.
Way up on top of a hill.
Attachments
Tom. You put rods in 1st?
Did you get special instructions report.... ,[emoji1787]
Sent from my E6810 using Tapatalk
Your a good son... The 99.00 Yes the Wagner does a surprising good Job.Mom wanted to swap out the old busted up bifolds in her basement. Got them trimmed to size and brought them home to spray them.
Used my friends Wagner on these because I didn't feel like using the hvlp. It did a better job than I expected. I'll second coat the fronts tomorrow![Image]()
-Rich
Sent from my E6810 using Tapatalk
Code book says 4" minimum embedding.
The thing had 5/16" wedge anchors barely in yet I had a big lever to pry it out. I was surprised how well it hung on
Some of the ones around here sheet the walls with plywood before sheetrock in kitchens. A little more to grab onto, less possibility of wire issues.
I had that for the pantry and the kitchen nook in my previous installs. Worked great for the pantry. Only reason it was nice for the nook was the electrical was all in the wrong spot and just had to unscrew the plywood. The pantry had the plywood covered with drywall, the nook didn't since cabinets were going into the space.
Finally got my hand into the Blum Tipon Blumotion Movento hardware. Reading the instructions is a lot harder that it is to use them. This will be used on filing drawers in the Kitchen Nook.Working on another floating vanity. All Blum Movento with TipOn...nice stuff. First time using it. Way better than the Salice I used last time.
https://www.instagram.com/p/BzuCGADAM37/?igshid=xnchaeyip29f
![Image]()
Got the siding wrapped up from the window replacement job.
PITA I had to fill and 8" void from the curtain wall to a very wavy brick veneer. In, out, up & down.
Of course the kid wont answer the door after he came home from school so I have to go back for to snap the upper grills and screens in.
PITA I had to fill and 8" void from the curtain wall to a very wavy brick veneer. In, out, up & down.
Of course the kid wont answer the door after he came home from school so I have to go back for to snap the upper grills and screens in.
Attachments
Joined
·
13,741 Posts
Tom, what lighting did you use in the wall cabs?
Joined
·
72,933 Posts
This is the 3 deck I've done for these folks. There's no color difference in the past 4 years. Can't remember when the capped came out. It was less than 10 years ago I think.
Mike.
_______________
[emoji631] [emoji631]
I use GMLighting LEDs, they’re placed in the LED channel they sell. I don’t like to see the individual LED’s.
They’re 3000K in this one, 12VDC, standard output.
http://gmlighting.net/
Tom
Joined
·
9,412 Posts
Started framing today.
![Image]()
4 Guys for 20' trusses:blink:
They handed it to you upside down... :whistling :laughing:
That's a good women right there... :thumbsup:
861 - 880 of 11,955 Posts
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
