Contractor Talk - Professional Construction and Remodeling Forum banner

Spa spillway waterfall help

2330 Views 1 Reply 2 Participants Last post by  charlie828
I recently remodeled a spa and used 12×18" pieces of travertine that over hang to create a waterfall. The problem is I do not have enough water flow to create a "sheet". I know I can replace the pump or direct more water to the spa but the is not an option. Can I make any special cut or create a somewhat steep angle on the spill way? It has a small slope towards the pool but the water still trickles off the rock and runs on the bottom of the travertine and down the front of the spa.



Any suggestions???? Please help
1 - 2 of 2 Posts
Undercut the bottom about 1/4 to 3/8 inch deep. Tilt blade 45 degrees or so to make sharp edge at bottom of your travertine. If water still wants to run back, male a wider relief cut. Good luck.
  • Like
Reactions: mikeswoods
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top