Contractor Talk - Professional Construction and Remodeling Forum banner

Sand blasting flow problems

20469 Views 4 Replies 5 Participants Last post by  Dyer
I'm new to the forum, not sure if this will end up where it needs to go, but here it is anyways, lol.
I am having problems getting even flow at the nozzle. I have a Schidt microvalve II and the blasting will work fine for a bit then no media comes. I chole the pot then it starts puking out sand then will work for a bit. sand is dry and the whole set up is fairly new. Glass bead 50/100 grit with a #5 nozzle, 185crm compressor. Any Ideas?
1 - 1 of 5 Posts
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.