Pulled screws in particle board

19644 Views 13 Replies 8 Participants Last post by Teetorbilt, Jul 15, 2005

Teetorbilt

Discussion Starter · Jul 12, 2005

I'm putting together a proposal to rehab a coffee bar inside of a bookstore, both are to remain open during the process and noise has to be minimal. Almost every cabinet door has hinge problems, some are broken and most have just the screws pulled out of the boxes.
I have tried Bondo in the past and didn't care for the results. For years now, I have used a quick set epoxy which does a pretty good job in most circumstances. These doors are going to get a daily workout and I'm seriously considering throughbolts but thought that I'd pick some brains first.

Save

1 - 1 of 14 Posts

ppmc

· #13 · Jul 14, 2005

Teetorbilt said:
I'm putting together a proposal to rehab a coffee bar inside of a bookstore, both are to remain open during the process and noise has to be minimal. Almost every cabinet door has hinge problems, some are broken and most have just the screws pulled out of the boxes.
I have tried Bondo in the past and didn't care for the results. For years now, I have used a quick set epoxy which does a pretty good job in most circumstances. These doors are going to get a daily workout and I'm seriously considering throughbolts but thought that I'd pick some brains first.

I agree with plumguy,I have used wood glue and then stuck in toothpicks,not good for a long fix for daily use though. :Thumbs:

See less See more

Save

1 - 1 of 14 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month