Contractor Talk - Professional Construction and Remodeling Forum banner
1 - 1 of 30 Posts

· Registered
5,083 Posts
Leo G said:
Undid the clamp system today. Took a little bit of prying to get it released, but not bad. Trim was taped on the rear and the jig was waxed, so no problems. Brought it back to the shop and jointed the bottom and then ran it through the saw. Then through the saw once more on the top to clean it up and size it. Put it on some saw horses and ran a router along the top with a round over bit. Next will be sanding, stain and finish.
Looks good. Thanks for posting neat stuff like this. It's always good to learn.
1 - 1 of 30 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.