Contractor Talk - Professional Construction and Remodeling Forum banner
1 - 1 of 5 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
GMP100-4 replaced circuit board and now I'm getting three blinks and the ignitor is not kicking in. prior to replacing the circuit board furnace was lighting just not staying lit. assumption is that a problem concerning a block stack sensor. I am pretty sure that is not the problem but the connector from the circuit board to the sensor not working properly any ideas?

thanks in advance
 
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top