Contractor Talk - Professional Construction and Remodeling Forum banner
1 - 10 of 10 Posts

·
operator
Joined
·
394 Posts
Discussion Starter · #1 ·
Does anyone know how to rebuild or get parts for a drive motor? My 267 track skid steer has a drive motor that is leaking. It still has full driving power and the machine tracks straight so I don't think its bad. I'm really hoping its just a hose since dirt and grime builds up behind the motors and has a tendency to wear holes in the hoses. I did a quick search online last night and all I came up with was new and reman drive motors and they were far from cheap. Any and all help is appreciated. Thanks
 

·
Registered
Joined
·
4,732 Posts
I'd say buy a shop manual and tear into it, but I just checked e-bay and they start at about $600:eek:
 

·
Registered
Joined
·
4,732 Posts
I figure if they can reman one why can't I? There's not a lot to them as far as the schematics online show. What's the worst that can happen, I break a broken part even more?
I'd sure as hell try too:thumbsup:
 

·
operator
Joined
·
394 Posts
Discussion Starter · #10 ·
Well after fighting with this damn machine I got the final drive out of it. Talked to a friend of mine and he just happened to have the same issue on his 257. Fortunately he found a guy who can rebuild these things so hopefully the bill isn't too bad. From all the research I've done I believe it just needs a seal kit which is a heck of a lot better than buying final drives. Now I just need to find a good degreaser. Never had a chance to clean it and its really bad especially after the hydraulic oil was blown all over. Any suggestions on degreasers guys?
 
1 - 10 of 10 Posts
Top