Contractor Talk - Professional Construction and Remodeling Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1,938 Posts
Discussion Starter · #1 ·
I've got to replace a dip tube. I'm going to use a Camco with the dual threads on them.

Have to cut to length. How far from the bottom should the tube be ?

Is there a gasket of some type that goes with it ? What kind, flat. O-Ring and where does it go ?
 

·
Registered
Joined
·
53 Posts
I've got to replace a dip tube. I'm going to use a Camco with the dual threads on them.

Have to cut to length. How far from the bottom should the tube be ?

Is there a gasket of some type that goes with it ? What kind, flat. O-Ring and where does it go ?
I ordered a dip tube , from Amazon , if I recall . I used the old dip tube as a guide to cut the new one to length .

It still had the flat rubber washer / gasket in the WH , so I re-used that .

I think the one I bought was Rheem ?

http://www.amazon.com/s/ref=nb_sb_n...er+dip+tube&rh=i:aps,k:+water+heater+dip+tube

God bless
Wyr
 
1 - 2 of 2 Posts
Top