Contractor Talk - Professional Construction and Remodeling Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
403 Posts
Discussion Starter · #1 ·
I have a 155,000 btu kerosene heater that isn't working properly. When I plug it in, the glow bar glows and the fan starts but it isn't creating the suction needed to provide the fuel.

I reset the psi as outlined in the manual and it just won't suck the fuel from the tank. I have replaced the line, cleaned every part on the heater, checked all the fuel lines and components for leaks.

I unhooked the air pump and blew into the air hose when the glow bar and fan started up, fuel was delivered and it ignited so nothing is plugged but it just wont suck the fuel out of the tank.

I am stumped. Any ideas?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top